Tarjeta de expansión para Raspberry Pi, permite conectar una gran variedad de shields de Arduino. Contiene interfaz ICSP, conector para XBee, conector USB y  ADC-10 bit. 

Características:

• Compatible con Arduino UNO y Leonardo.
• Soportada por Raspberry Pi 1 modelo A+ y B+
• Soportada por Raspberry Pi 2 modelo B.
• Soportada por Raspberry Pi 3
• Conversor ADC de 10 bit, 11 canales
• Conectores para shields de Arduino.
• LEDs indicadores de estado.
• Interfaz para conectar varios sensores.

• Dimensiones: 85 x 63mm.

1. Arduino connector : for connecting Arduino shields
2. ICSP interface : Arduino ICSP
3. XBee connector : for connecting XBee communication modules
4. Sensor interface : for connecting sensors
5. Raspberry Pi connector : for connecting Raspberry Pi
6. USB TO UART
7. TLC1543 : AD converter
8. PCF8563 : RTC
9. CP2102
10. 32.768KHz crystal : for RTC
11. Power indicator
12. XBee state LED
13. XBee and Arduino interface RESET button
14. XBee EASYLINK button
15. RTC battery holder : for CR1220 button battery
16. TLC1543 reference voltage configuration jumper
17. RTC jumper
18. UART jumper
    
    • when connecting P_RX and CP_TX, P_TX and CP_RX respectively, USB TO UART is connected to Raspberry Pi serial port
    • when connecting XB_RX and CP_TX, XB_TX and CP_RX respectively, USB TO UART is connected to XBee serial port
    • when connecting XB_RX and P_TX, XB_TX and P_RX respectively, Raspberry Pi serial port is connected to XBee serial port
19. Arduino AD selection jumper
    
    • short 2 and 3 : Arduino A0-A5 as AD input
    • short 1 and 2 : Arduino A0-A5 as digital control
20. Arduino I2C selection jumper
    
    • short the jumper : Arduino A4-A5 as I2C control (the A4-A5 of Arduino AD selection jumper should be opened)
21. Arduino SPI selection jumper
    
    • short 1 and 2 : Arduino D11-D13 as SPI control (default)
    • short 2 and 3 : Arduino D11-D13 as digital control

Manual de usuario

Enlace al fabricante:

Palabras claves: shield, tarjeta, HAT, adaptador Arduino Raspberry